Saturday, 18/11/2017 | 12:10 UTC+8

What is Silica Fume?

Post by relatedRelated post

Silica fume is a byproduct of producing silicon metal or ferrosilicon alloys. One of the most beneficial uses for silica fume is in concrete. Because of its chemical and physical properties, it is a very reactive pozzolan. Concrete containing silica fume can have very high strength and can be very durable. Silica fume is available from suppliers of concrete admixtures and, when specified, is simply added during concrete production. Placing, finishing, and curing silica-fume concrete require special attention on the part of the concrete contractor.

Silicon metal and alloys are produced in electric furnaces. The raw materials are quartz, coal, and woodchips. The smoke that results from furnace operation is collected and sold as silica fume, rather than being landfilled. Perhaps the most important use of this material is as a mineral admixture in concrete.

Silica fume consists primarily of amorphous (non-crystalline) silicon dioxide (SiO2). The individual particles are extremely small, approximately 1/100th the size of an average cement particle. Because of its fine particles, large surface area, and the high SiO2 content, silica fume is a very reactive pozzolan when used in concrete.

High-strength concrete is a very economical material for carrying vertical loads in high-rise structures. Until a few years ago, Grade 40 concrete was considered to behigh strength. Today, using silica fume, concrete with compressive strength in excess of Grade 100 can be readily produced.

The greatest cause of concrete deterioration today is corrosion induced by deicing or marine salts. Silica-fume concrete with a low water content is highly resistant to penetration by chloride ions. More and more transportation agencies are using silica fume in their concrete for construction of new bridges or rehabilitation of existing structures.

Silica-fume concrete does not just happen. A specifier must make a conscious decision to include it in concrete to achieve desired concrete properties. Assistance in specifying silica-fume concrete for high strength or increased durability can be obtained from the SFA or from major admixture suppliers.

Silica fume for use in concrete is available in wet or dry forms. It is usually added during concrete production at a concrete plant as shown in the photo. Silica fume-concrete has been successfully produced in both central-mix and dry-batch plants. Assistance is readily available on all aspects of handling silica fume and using it to produce consistent, high-quality concrete.

Silica-fume concrete should be transported, placed, finished, and cured following the good concreting practices outlined. Flatwork containing silica fume concrete generally requires less finishing effort than conventional concrete. To gain the most benefits from using silica fume, the concrete must be cured effectively. The SFA or your concrete supplier can provide any necessary assistance concerning construction operations.

Related Topic: GGBS and Fly Ash in Malaysia

Source: silicafume.org

About

POST YOUR COMMENTS

Your email address will not be published. Required fields are marked *

F